-----When button Al is armed (it takes the red color)
-----and that the wheels touch the ground, then the
-----spoilers are applied, the brakes are applied and
-----the thrust reversing is put in function.
-----With the AL armed the automatic approach is put out
-----at 250 feet and the pilot must then take the
-----controls to finish is landing.
[ ] ------------Spoilers
[ ] +------Spoilers auto-armed
[ ] +--Raise the pilot's seat by one position
---------------Repeat until you can see the desk
[ ] + ---------------Lower the pilot's seat by one position
[ ] ------------Lower the radar bulb if the landing gear is up
[ ] ,------Reverse thrust
_________________________
PRE FLIGHT
[1] Select the Aircraft/Map menu of FS200 or FS2002
On the Map window that appear
take note of the altitude of the desk.
[2] Take note of the heading of the oblique
desk.
_________________________
TAKE OFF
[1] Apply the parking brakes
[2] Lower the flaps at the third position
(3 times F7)
[3] Engine at full power
wait until the engine reach his full
power
[4] Release the brakes
_____________________________
CRUISE
[1] Raise the landing gear
[2] Raise the flaps one by one position
[3] If you need to quickly reduce speed
lower the flaps to the
first or second position
BEWARE
DO NOT USE SPOILERS TO REDUCE SPEED
IN CRUISE
______________________________
LANDING
[1] Button AL armed (or auto-arm the spoilers)
[2] Reduce the power of the engine
[3] Lower the flap by one position
Repeat four times this maneuver
[4] Lower the landing gear
[5] Approach speed: 120 kts
Landing speed: 90 kts
Ajust the power of the engine
to maintain speed at least 90 kts
If necessary during the approach
make a pause and raise the seat (or lower it)
to see the desk